This simple puller easily manage to dismantle a 3- or 4-bladed Michigan propeller on a 1"1/4 or 32mm shaft.
The nuts behind the propeller is loosened and the one at the outside is dismounted. The inner one is left with approximate 8-10 mm space between the hub and the nut.
Place the puller parts on the propeller, be sure the thread part only presses on the hub and not on the propeller blades. If necessary something has to be put between the plate and the hub. Place a wooden block between the propeller and the hull, - and then tighten the screws until the propeller loosens.
2004
www.moonraker.dk / to@moonraker.dk